Weslo Pursuit G 3.1 Bike Manual page 15

HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted.
To adjust the drive belt, you must remove the pedals,
the resistance knob cover, and the shields.
Using an adjustable wrench, turn the left pedal
clockwise and remove it. Then, turn the right pedal
counterclockwise and remove it.
Press the tabs on the
sides of the resistance
control and pull the
Resistance Knob (14)
upward off the resis-
tance control.
See the EXPLODED DRAWING on page 19.
Remove the four M3.5 x 19mm Screws (43) and the
six M4 x 19mm Screws (27) from the Left and Right
Shields (9, 10). Then, remove the Left and Right
Shields.
14
Tab
Tab
Loosen the two M10 Flange Locknuts (37)——one on
each side of the Eddy Mech (22). Then, tighten the two
M6 Nuts (38) until the Drive Belt (not shown) is tight.
When the Drive Belt is tight, tighten the M10 Locknuts.
22
When the drive belt is correctly adjusted, reattach the
shields, the resistance knob, and the pedals.
15
38
37