Weslo Pursuit G 3.1 Bike Manual page 10

11. Untie and discard the wire tie on the Reed
Switch Wire (33).
While a second person holds the Console (8)
near the Upright (3), connect the wire on the
Console to the Reed Switch Wire (33).
Insert the excess wire into the Upright (3) or into
the Console (8).
Tip: Avoid pinching the wires. Attach the
Console (8) to the Upright (3) with four M4 x
13mm Truss Screws (42).
12. Identify the Right Pedal (12), which is marked
with an “"R.”"
Using an adjustable wrench, firmly tighten the
Right Pedal (12) clockwise into the right side of
the Crank (24).
Firmly tighten the Left Pedal (not shown) coun-
terclockwise into the left side of the Crank (not
shown).
Adjust the strap on the Right Pedal (12) to the
desired position and press the end of the strap
onto the tab on the Right Pedal. Adjust the
strap on the Left Pedal (not shown) in the
same way.
13. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.
11
8
12
10
Avoid pinching
the wires
33
3
42
24
Strap
12
Tab