Trouble-Shooting And Maintenance - Weider Pro 9510 User Manual

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The
home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the home
gym system, can stretch slightly when it is first used.
If there is slack in the cables before resistance is felt,
the cables should be tightened. Slack can be
removed from the cables by tightening the 1/4" Nylon
Locknuts (2) at the end of the Long Cable (23) (see
drawing 1) and at the end of the Short Cable (58)
(see drawing 2). To do this you may need to remove
the Small "U" -Bracket (67) from the Weight Tube (63)
or remove the 3 1/2" Pulley (15) from the Long "U"-
Bracket (57). Make sure that the cables are not too
tight, or the Top Weight (76) will be lifted off the
weight stack.
Additional slack can be removed by moving the 3 1/2"
Pulley (15) to the other hole in the Long "U"-Bracket
(57). Remove the 3/8" Nylon Locknut (21) and the
3/8" x 2" Bolt (12) from the Cable Trap (66), Pulley,
and Long "U"-Bracket. Re-attach the Pulley and
Cable Trap. Be sure that the Cable trap is in the
proper position and that the Cable and Pulley
move smoothly.
If the cables need to be replaced, see the back cover
of this manual.
1
23
67
2
76
2
23
15
66
57
12
21
2
58
21