Maintenance And Trouble-Shooting - Weider X2 User Manual

Maintenance and Trouble-shooting

Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately.
The training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
Tightening the Cables
Woven cable, the type of cable used on the training system,
can stretch slightly when it is first used. If there is any
slack in the cables before resistance is felt, the cables
should be tightened.
Slack can be removed by moving one or both of the
Pulleys (50) attached to the Pulley Plates (25) to different
holes in the Pulley Plates. To do this, remove the M10 x
50mm Bolt (54) and the M10 Nylon Locknut (60). Move
the Pulley and the Pulley Covers (28) one hole up or
down and re-attach them with the Bolt and Nylon
Locknut. Make sure that the Low Cable (40) or the
High Cable (48) is in the groove of the Pulley.
After moving one of the Pulleys (50) one hole up or down,
test the training system to see if the cables are tight. If
the cables are still loose, move the second Pulley one
hole. Repeat this process until the cables are tight.
Additional slack can be removed by adjusting the M8 x
75mm Eyebolt (69) to which the Low Cable (40) is
attached. To do this, loosen the M8 Nylon Locknut (70)
without removing it. Then, tighten the M8 Plain Nut (70)
further onto the Eyebolt. Finally, retighten the M8 Nylon
Locknut.
Note: If a cable tends to slip off the pulleys often, the
cable may have become twisted. Remove the cable
and re-install it.
If the cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
All manuals and user guides at all-guides.com
19
50
54
25
28
60
50
28
40
4
40
69
71
70
48