Assembling The Printer - ENCAD 215360-01 Quick Start Manual

NovaJet 800 Series Printer Quick Start Guide

Assembling the printer

1 Open the box containing the stand/takeup. Remove the entire
contents of this box and place nearby for easy access. In the same
box, locate the screws for use in subsequent steps. There are two
types of screws: 1) Sixteen size 10-24 screws to attach the feet to
the stand legs and the stand legs to the printer; and 2) Eight size 8-
32 screws to attach the dryer brackets to the stand legs and the
dryer to the dryer brackets. (The 10-24 screws are a larger diameter
than the 8-32 screws.)
2 Attach the feet to the stand legs using eight of the size 10-24
screws. Note that each foot has two casters, only one of which
locks. Lock the casters to prevent the stand from rolling during
subsequent assembly.
3 Locate the box containing the printer head. It should already be open
with the underside of the printer facing up.
4 One of the stand legs has a connector in the center of the leg. (See
the following illustration.) Pull the connector from the access hole in
the leg and remove the tiewrap holding the connector in place.
Attach the connector to the receptacle on the bottom of the printer
head. Orient the stand legs so that the roll holder brackets are
facing the center of the printer head and align with the holes in the
bottom of the printer head. Attach both stand legs to the printer head
using eight of the size 10-24 screws. Note: To help ensure that the
legs seat properly on the printer head, attach screws snugly in
opposite corners first. Then, when all screws are in place, tighten
them securely.
6