Moving The Carriage; Installing The Cutter - ENCAD 215360-01 Quick Start Manual

To unload the takeup roll
1 Press Cut to cut the media.
2 Roll the printed or unused media onto the takeup.
3 Slide the media and core out of the printer.
4 Release the adjustable roll guide.

Moving the carriage

When not in use, the ink cartridges rest in the service station at the right side of
the printer. This device seals the inkjets to prevent them from drying out. With
the power turned on, select Utility Menu/Access Menu/Access Left or
Access Right on the control panel to move the carriage away from the service
station so that you can install, change, adjust or clean the ink cartridges, change
the cutter, or clean the service station. Note: Use Access Right to change the
cutter. The cutter is not accessible from the Access Left position.
! Do not move the carriage manually as you could damage the printer.

Installing the cutter

A cutter located in the ink cartridge carriage cuts roll media. The printer is
shipped with the cutter installed. Use the following procedure to replace the
cutter, when necessary.
! Be careful when handling the cutter to avoid injury.
! Cutting media with a worn cutter can cause the media to jam and create
a ragged cut line. Replace the cutter to avoid this condition. Do not cut
media on the printer with an external knife, as you could seriously dam-
age the platen and void the warranty.
To install the cutter
1 Press Utility Menu/Access Menu/Access Right to move the
carriage out from the service station.
NovaJet 800 Series Printer Quick Start Guide
25