Removing Protective Shipping Material - ENCAD 215360-01 Quick Start Manual

17 Plug the power cable from the dryer into the power receptacle on
the back of the printer.
18 A cable guide is included to keep the power cord out of the way.
Remove the liner covering the adhesive on the back of the cable
guide. On the NJ850, attach the cable guide to any convenient
location. On the NJ880, attach to a flat area above the leg as
shown in the following illustration.
CAUTION: Never open the dryer. There are no user serviceable
parts inside. Refer servicing to qualified service personnel only.

Removing protective shipping material

CAUTION: Before turning on the printer, make sure to remove the protective
material that secures the carriage and remove the protective film from the
control panel. There is one shipping bracket located on the platen on 60"
NovaJet 850 printers. There are three shipping brackets located on the platen
on NovaJet 880 printers, plus two brackets on the back of the printer. Make
sure you remove these brackets.
Heating Chamber Power Connection/Plug
CAUTION: Once the dryer is plugged in, there is continu-
ous power to the dryer, even when the printer is turned
off.
NovaJet 800 Series Printer Quick Start Guide
13