Setting Up A Wired Connection - Technicolor MediaAccess TG789vn Setup And User Manual

3 MANUAL INSTALLATION

3.3.2 Setting up a Wired Connection

Requirements
Both your network device (for example, a computer, a gaming console,...) and MediaAccess Gateway must have a free

Ethernet port.
Your network device must be configured to obtain an IP address automatically. This is the default setting.

Ethernet cable
In your package, you will find a cable with yellow connectors. This is the Ethernet cable.
Procedure
Proceed as follows:
1 Connect one end of the Ethernet cable to one of the yellow Ethernet ports of your MediaAccess Gateway:
You can not use the red WAN port to connect to the local Ethernet network. The WAN port can only be used to
connect your MediaAccess Gateway to your broadband source.
For more information, see
2 Connect the other end of the Ethernet cable to your network device.
The MediaAccess Gateway does not support Power over Ethernet (PoE). All network devices that are connected
to the MediaAccess Gateway must be powered by their own power source.
3 Your network device is now connected to your network. No additional configuration is needed unless specified by your
service provider.
30
"1.2 User Scenarios" on page 5.
DMS-CTC-20101206-0033 v1.0