Operation - Titan TTL488GDO Safety And Operating Manual

- Never store the product or fuel container inside where there is an open flame, such as near
a water heater.
- If fuel is spilled, do not attempt to start the product, but move it away from the area of
spillage before starting.
- Always replace and securely tighten the fuel tank cap after refuelling.
- Drain fuel outdoors only.
6. If the cutting mechanism strikes any foreign object or the product starts making any unusual
noise or vibration, shut off the power source and allow the product to stop. Disconnect the
spark plug wire from the spark plug and take the following steps:
- Inspect for damage,
- Check for, and tighten, any loose parts,
- Have any damaged parts replaced or repaired with parts having equivalent specifications.

Operation

1. This product should not be used for any other purpose than described. Note that national
regulations can restrict the use of this product.
2. Working with this product is demanding; therefore ensure you are physically and mentally fit
to complete the job safely. Do not use the product when you are tired, ill or under the
influence of alcohol or other drugs.
3. Pay attention to your posture; always use the provided harness and keep your back straight
at all times. Do not overwork yourself. Take regular breaks on regularly base to ensure
concentrated work and full control over the product.
4. Keep a firm footing and balance during operation. Always be sure of a safe and secure
operating position, whilst using the product. Never use the product standing on steps or a
ladder.
5. Always wear substantial footwear and long trousers while operating. Do not operate the
product when barefoot or wearing open sandals. Wear protective glasses or goggles.
6. Thoroughly inspect the area where the product is to be used and remove all objects which
can be thrown by the product.
7. Before using the product and after any impact, check for signs of wear or damage and repair
as necessary.
8. Never operate the product with damaged guards or without the guards in place.
9. Keep hands and feet away from the cutting means at all times and especially when
switching on the motor.
10. Never allow children or people unfamiliar with the instructions to use the product.
11. Stop using the product while people, especially children, or pets are nearby.
12. Only use the product in daylight or good artificial light.
13. Stop the engine before
- Cleaning or when clearing a blockage,
- Checking, carrying out maintenance or working on the product,
- Adjusting the working position of the cutting device,
- Leaving the product unattended.