Auxiliary Handle; Starting And Stopping - Titan TTL488GDO Safety And Operating Manual

4. AUXILIARY HANDLE

Adjust the position of the auxiliary handle (A14) on the
upper shaft.
1). Loosen the bolts on the auxiliary handle (A14) and
adjust the position. (See Fig. 12)
2). Afterward tighten the bolts.

5. STARTING AND STOPPING

This product is controlled by the control handle. For
operation three steps are necessary: Firstly, the ignition
switch (A18) must be put into its on position "I". Then the
throttle interlock (A19) must be pressed to disengage the
throttle trigger. Finally press the throttle trigger (A17).
(See Fig. 13a)
1). Starting
a). Place the product on a flat, stable surface. Ensure
that the attachment in use does not touch the ground or
any objects.
b). Set the ignition switch (A18) to its on position "I".
(See Fig. 13b)
c). If the engine is cold, move the choke lever (A3) to
the "CLOSE" position
with 6 times until fuel is visible. (See Fig. 13c)
d). If the engine is warm, move the choke lever (A3) to
the "OPEN" position
(See Fig. 13d)
25CC PETROL MULTI TOOL TTL488GDO
and depress the primer (A4)
, do not press the primer.
Fig. 12
A19
A18
Fig. 13a
Fig. 13b
Fig. 13c
Fig. 13d
A14
A17
A3
A4
A3