Assembly Instructions; Auxiliary Handler Assembly; Assemble Attachments To Suit Intended Application; Fit The Grass Trimmer Shaft To The Main Unit - Titan TTL488GDO Safety And Operating Manual

ASSEMBLY INSTRUCTIONS

WARNING! Be careful with small parts that are
removed during assembly or when making
adjustments. Make sure you do not lose them.

1. AUXILIARY HANDLER ASSEMBLY

1). Loosen the outer pre-assembled screws on the
auxiliary handle (A14).
NOTE: There are holes on the bottom side of the upper
shaft above the clamp to adjust the position of the
handle.
2). Align the step guard (A10) with the screw to one of the
holes in the shaft and insert the shorter screw into the
hole.
3). Place the handle onto the shaft from the top and
secure it with the longer screws. Tighten them with the
hex key (D4). (See Fig. 1)
2. ASSEMBLE ATTACHMENTS TO SUIT INTENDED
APPLICATION
WARNING! Read all the instructions carefully! Do
not start the product until it is completely
assembled! Always wear gloves during assembly!
This product can be used with different cutting heads for
different applications. Follow the assembly steps for
respective application.
Grass trimmer
With the grass trimmer head and its relative attachments
correctly assembled, the product can be used as a grass
trimmer intended to cut smaller types of weed, lawngrass
or similar soft vegetation. (See Fig. 2)
1). Fit the grass trimmer shaft (B1) to the main unit.
a) Align the shaft(B1) with the clamp (A11) so that the
hole in the shaft(B1) is orientated to the locking pin.
(See Fig. 3a)
b) Pull out the locking pin (A12) and insert the
shaft(B1) into the clamp (A11). Release the locking pin
and ensure it engages in the hole. (See Fig. 3b)
c) Secure the connection by tightening the locking
knob (A13) clockwise. (See Fig. 3c)
25CC PETROL MULTI TOOL TTL488GDO
A14
Fig. 1
Fig. 2
A11
B1
Fig. 3a
B1
Fig. 3b
A13
Fig. 3c
A10
A11
A12