Blade (Hedge Trimmer); Air Filter; Fuel Tank; Fuel Filter - Titan TTL488GDO Safety And Operating Manual

6. To replace the trimming line, press the release latch of
the trimmer head housing to open the cover.
7. Cut a new 6 m long trimming line with a diameter of 2
mm. Form a loop at the middle of the line and insert this
loop into the hook on the spool. (See Fig. 18c)
8. Wind the two parts of the trimming line in clockwise
direction firmly around the spool each part in the guide
on the spool. (See Fig. 18d)
9. Insert each end of the threads in the respective holes.
The threads should stick out 150 mm on each side.
10. Screw the bumper (B7) clockwise until it is
completely and safely locked.
WARNING! After changing the trimming line, run
the product under no load for at least a minute to
make sure that the line and the product are
operating correctly! WARNING! Never use steel
thread! Always use cutting means in perfect
condition, free of damage!

BLADE (HEDGE TRIMMER)

1. Keep the hedging blade (C1) clean and free of debris.
Remove trimmings.
2. Keep the hedging blade (C1) sharp to retain a good
cutting performance. Replace a worn or damaged cutting
blade with a new one of the same type.
3. Lubricate the hedging blade (C1) after each use to
prolong the life span of cutting blade and product. Apply
light machine oil along the edge of the cutting blade.

AIR FILTER

1. Inspect the air filter regularly. Replace it with a new
one if necessary.
2. Open the air filter case (A5) with the cross-head
screwdriver (D1, D2), and remove the filter. (See Fig. 19)
3. Tap the filter on a stable surface to remove dust. Use
compressed air (max. 3 bar) to remove stubborn dust.
4. Apply a small amount of air filter oil on the filter to
increase the performance of the filter. Wring out surplus
oil and put the filter into the case.
5. Close the air filter cover.

FUEL TANK

1. Empty the fuel tank when storing the product over 30
days to prevent the fuel from deteriorating.
2. Unscrew and remove the fuel tank cap (A6) and use a
proper fuel pump to empty the fuel into a suitable
container.

FUEL FILTER

The fuel tank of this product is fitted with a filter located
at the free end of the fuel pipe. Ask an authorised service
centre or similar qualified person to check and where
necessary replace it at regular intervals.
25CC PETROL MULTI TOOL TTL488GDO
Fig. 18c
Fig. 18d
Fig. 19
A5