Remote Controller Connection - Takagi T‐H2‐DV Installation Manual And Owner's Manual

TM‐RE30 REMOTE CONTROLLER CONNECTION
1. Disconnect power supply from the T‐H2‐DV/T‐H2‐OS.
2. Take off the T‐H2‐DV/T‐H2‐OS's front cover.
3. Locate the remote controller terminal, pictured below (located around the upper right‐hand side
of the computer board).
4. Open the plastic cover of the TM‐RE30, and then attach the two fork terminals to connector base
of the backside the TM‐RE30 with two screws. Make sure the terminals are firmly fixed.
5. Pull the remote's wires through the rubber grommet at the bottom of the water heater's casing.
6. Properly attach the remote's wires to the remote controller terminal on the computer board.
polarity)
*Do NOT jump.
7. Replace Front Cover securely.
8. Wires used for the remote controller connection must be:
• Minimum 18AWG wire (No polarity)
• Maximum 400 feet long
*For detailed connection instructions to the TM‐RE30, refer to the TM‐RE30's Installation Manual.
Remote controller terminal of the
Connect to these terminals
T‐H2‐DV/T‐H2‐OS
Front of remote
Connect other end to these terminals
24
│
Page
Installation
(No
Back of remote