Download  Print this page

After-Sales Service; Installation 10 - Whirlpool Refrigerator-freezer Instructions For Use Manual

Hide thumbs
   

Advertisement

1gb33020a.fm5 Page 10 Tuesday, February 20, 2001 4:37 PM
Before contacting After-Sales Service:
1. See if you can solve the problem yourself
with the help of the "Troubleshooting guide".
2. Switch the appliance on again to see if the
problem has been solved.
If it has not, disconnect the appliance from
the power supply and wait for about an hour
before switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
• the nature of the problem
• the model
• the Service number (the number after the
word SERVICE on the data plate on the
inside of the appliance)
• your full address
• your telephone number and area code
Install the appliance away from heat sources.
Install the appliance in a dry, well-ventilated
place.
Do not obstruct the top and bottom vent zones.
Clean the inside (see "How to clean the
refrigerator compartment").
Fit the accessories supplied.
Electrical connection
Electrical connections must be made in
accordance with local regulations.
Voltage and power consumption are
indicated on the rating plate (at the side of the
crispers).
Freestanding appliances
(not built-in)
Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the
appliance (see figure).
To optimize appliance efficiency, leave a 5
cm gap above the appliance and make sure
that adjacent kitchen units are sufficiently
distanced to allow air circulation.
Ensure that the appliance is level, using the
front adjustment feet if necessary.
10

AFTER-SALES SERVICE

Note:
The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
INSTALLATION
Regulations require that the appliance is
earthed.
The manufacturer declines all liability for
injury to persons or animals and for
damage to property resulting from failure
to observe the above procedures and
reminders.
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
Do not use extension leads or adaptors.
Disconnecting the appliance
It must be possible to disconnect the appliance
by unplugging it or by means of a two-pole switch
fitted upline of the socket.

Hide quick links:

Advertisement

loading

  Also See for Whirlpool Refrigerator-freezer