Table of Contents
Advertisement
30802003GB.fm Page 10 Monday, December 19, 2005 12:18 PM
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself with
the help of the Trouble-shooting guide.
2. Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
INSTALLATION
• Install the appliance away from heat sources.
Installation in a hot environment, direct
exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will
increase power consumption and should
therefore be avoided.
• If this is not possible, the following minimum
distances must be respected:
•30 cm from coal or paraffin stoves;
•3 cm from electric and/or gas stoves.
• Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the
appliance.
• Install the appliance in a dry, well-ventilated place,
and ensure it is level, using the front adjustment
feet if necessary.
• Clean the interior.
• Fit the accessories.
10
Specify:
• the nature of the problem
• the model
• the Service number (the number after the word
SERVICE on the rating plate on the inside of the
appliance)
• your full address
• your telephone number and area code
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
Electrical connection
• Electrical connections must be made in
accordance with local regulations.
• Voltage and power consumption are indicated
on the rating plate inside the appliance.
• Regulations require that the appliance is
earthed.
The Manufacturer declines all liabilities for
injury to persons or animals or damage to
property resulting from failure to observe
these regulations.
• If the plug and socket are not of the same type,
have the socket replaced by a qualified
electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch
fitted upline of the socket.
Advertisement
Table of Contents
