Excalibur RS-330-EDP Operation Manual page 14

Installer Programmable Features (cont'd)
Feature #6 Low Temp Crank Extender
0ms (Off) (press "lock" button to program)
200ms (press "unlock" button to program) - DEFAULT
300ms (press "trunk" button to program)
400ms
(press "start" button to program)
when the vehicle's interior temperature is below freezing, this feature adds extra
crank time to the base timing (see installer feature #5)� It applies to tachless modes
only (installer feature #2)
Feature #7 Doorlocking Output Functions
0�8 Second Outputs
3 Second Outputs
Double 0�8 Sec Unlock Output
Total Closure Lock Output
This single feature gives the installer several needed options, to match the system's
doorlocking outputs to suit different vehicle requirements.
0�8 Second Outputs on both Lock and Unlock outputs�
3 Second Outputs on both Lock and Unlock outputs�
Double 0�8 Sec Unlock Output w/ single 0�8 sec Lock output�
Total Closure Lock Output gives a 28 second Lock output and a 0�8 second
unlock output�
Feature #8 Remote Start Lock Control
Off
Lock After Start
Unlock before start
Unlock Before+Lock After Start (press "start" button to program)
This feature allows for OEM alarm/lock control in relation to remote start operations
thus eliminating extra wiring�
Feature #9 Turbo Timer
Off (press "lock" button to program) - DEFAULT
Run 1 Minute (press "unlock" button to program)
Run 2 Minutes (press "trunk" button to program)
Run 3 Minutes (press "start" button to program)
This feature keeps the engine running briefly after it is turned off by the key to help
cool down turbocharging components and enhance longevity� This feature should
only be programmed by the installer, and the operation of this feature depends
on the correct connection of the neutral safety wire to the vehicle's parking brake�
Please refer to the installation manual for details�
Feature #10 Manual Transmission Remote Start
Off (press "unlock" button to program) - DEFAULT
On (press "lock" button to program)
Enabling this feature requires a "setup" procedure to be performed that ensures
the transmission is in neutral before remote start can be performed� See page 8 for
more information�
14
(press "lock" button to program) - DEFAULT
(press "unlock" button to program)
(press "trunk" button to program)
(press "start" button to program)
(press "lock" button to program) - DEFAULT
(press "unlock" button to program)
(press "trunk" button to program)