NEC Univerge SV8300 Manual page 46

Overlap Receiving - Q-SIG
■
Conditions on Call termination to extension
Same conditions as Q-SIG en-bloc receiving are applied.
Single Line Station, Multiline Terminal, PS, Attendant Console, and ISDN Terminal can be a destination sta-
tion.
■
Conditions on Tandem connection
Same conditions as Q-SIG en-bloc receiving are applied.
1. When a destination station has set Call Forwarding - All Calls/Busy Line/No Answer, tandem connection is
available.
2. Without routing through a destination station, direct tandem connection is available with LCR number de-
velopment.
3. Types of outgoing trunks are ISDN, CCIS, and ACIS.
4. When the outgoing trunk is ISDN or CCIS, the SV8300 sends SETUP or IAI message after all digits of
number are received. When the outgoing trunk is ACIS, the SV8300 seizes a trunk and sends the received
digits after all digits of number are received.
5. Tandem connection from Q-SIG to a CCIS trunk route is not available, but LCR from Q-SIG to CCIS is
available.
6. Tandem connection from Q-SIG to an ISDN trunk route is available with a maximum of
ber conversion including access code. LCR from Q-SIG to ISDN is also available.
7. Tandem connection from Q-SIG to an ACIS trunk route, and LCR from Q-SIG to ACIS are available.
Interactions
Same conditions as Q-SIG en-bloc receiving are applied.
Call Forwarding - All Calls/Busy Line/No Answer can be set to the destination station. The forward destination
can be a station and a trunk (ISDN, CCIS, ACIS).
Page 38
UNIVERGE SV8300 Features and Specifications Manual (ISDN/Q-SIG)
digits of num-
eight
NWA-033632-001, Issue 1