NEC Univerge SV8300 Manual page 24

CPN To Terminating User - Display
6. Calling Name Display on ISDN Terminals is not supported.
7. Calling Name Display or Calling Number Display can be selected as the initial display in station Class of
Service.
8. The display can be changed to the calling name or calling number by pressing the display selection key on
a Multiline Terminal or an Attendant Console while the number or name is displayed.
9. When the terminating system is set to Trunk Direct Appearance or Attendant Console, the calling name is
displayed only after the called party answers the call.
10. Conditions on Tandem Connection
a. The calling name received from ISDN is relayed, only via CCIS, with tandem connection. (A
maximum of 16 characters)
b. When Call Forwarding routes an incoming call from ISDN to CCIS, the calling name is relayed via
CCIS to the destination of Call Forwarding.
c. When the calling name from NI-2 is received as a FACILITY message, the name cannot be relayed to
CCIS. Only when the calling name from NI-2 is received as a SETUP message, the name can be
relayed to CCIS.
d. Only when the calling name from DMS100 is received as a SETUP message, the name can be relayed
to CCIS.
11. Conditions with Other Services
a. The calling name received from ISDN has priority over the calling name registered to Station Speed
Dialing by system data, so the former is displayed even though the latter has been assigned by system
data.
b. If the calling name is not received from ISDN, the calling name assigned by system data is displayed
if available.
c. When a call is relayed to CCIS with tandem connection, the calling name is not relayed to CCIS, if
the name is not received from NI-2, even though the calling name has been assigned by system data.
However, when Call Forwarding - No Answer routes an incoming call from ISDN to CCIS with
tandem connection, the calling name assigned by system data is relayed to CCIS.
Page 16
UNIVERGE SV8300 Features and Specifications Manual (ISDN/Q-SIG)
NWA-033632-001, Issue 1