III. INSTALLATION
Jumper Settings
1. Onboard Multi-I/O Selection (SIO)
You can selectively disable each onboard multi-I/O item (floppy, serial, parallel,
and IrDA) through the Chipset Features Setup under BIOS SOFTWARE or
disable all multi-I/O items at once with the following jumper so you can use
your own multi-I/O card.
Multi-I/O
SIO: M/IO
Enable
[1-2] (Default)
Disable
[2-3]
2. Flash ROM Boot Block Programming (BBLKW)
This sets the operation mode of the boot block area of the Programmable Flash
ROM to allow programming in the Program position. This is required only if
prompted by the Flash Memory Writer Utility as shown in BIOS SOFTWARE.
Programming
Protect
Program
1 2 3
SIO
Enable
(Default)
BBLKW
[1-2] (Default)
[2-3]
1 2 3
BBLKW
Protect
(Default)
ASUS KN97 User's Manual
1 2 3
SIO
Disable
1 2 3
BBLKW
Program
13