Asus KN97 User Manual page 19

III. INSTALLATION
The ASUS KN97 As Shipped
Four screws should be showing next to each corner of the SEC CPU Slot using two
attach mount bridges from the underside of the motherboard. A bottom heatsink
support base must be mounted over the two chipsets located to the side of the slot.
Installing the Pentium II Processor:
1. Mount the Pentium II Retention Mechanism: The retention mechanism is
designed to fit into the SEC slot only one way.
TIP: Orient the mechanism's lock holes toward the motherboard's chipsets (see
motherboard layout for the location of the Intel 440FXPCIset).
Be sure to align the notch in the mechanism with the small rib on one side of the
slot. Screw the captive nuts in place
WARNING! Do not overtighten the captive nuts. Doing so could damage your
motherboard. Tighten captive nuts to no more than 6 1 inch/pound.
Captive nut
Lock holes
ASUS KN97 User's Manual
NOTE: Encircled items are screws from
the mount bridges (1 & 2)
SEC CPU slot
Captive nut
19