Jumper Settings - Asus SP98-N User Manual

III. INSTALLATION

Jumper Settings

1. Real Time Clock (RTC) RAM (RTCLR)
The CMOS RAM is powered by an onboard button cell battery. To clear the
RTC data: (1) Turn off your computer and remove the AC power , (2) Move this
jumper to "Clear CMOS" (3) Move the jumper back to "Normal Setting," (4)
Turn on your computer, (5) Hold down <Delete> during bootup and enter BIOS
setup to re-enter user preferences.
Battery Test Jumper (RTCLR)
You can test the battery's current by removing the RTCLR jumper and touching
the "Normal Setting" pins with the test probes from a battery tester.
WARNING! You must unplug the power cord to your power supply to en-
sure that there is no power to your motherboard. The CMOS RAM con-
taining BIOS setup information may be cleared by this action. You should
enter BIOS to "Load Setup Defaults" and re-enter any user information
after removing and reapplying the RTCLR jumper.
RTC RAM
Normal Setting
Clear CMOS
SP98-N Real Time Clock (RTC) RAM
RTCLR
[1-2] (Default)
[2-3] (momentarily)
WARNING!
setting only when clearing RTC data. Otherwise, BIOS
setup information may be cleared.
RTCLR
3
2
1
Normal Setting (Default)
ASUS SP98-N User's Manual
Move the jumper to the "Clear CMOS"
RTCLR
3
2
Battery test
1
Clear CMOS
13