Asus KN97 User Manual page 24

2. Secure the SEC Card: Place the four plastic washers over the mount bridge
screws (encircled) and secure the C-P6S1 Pentium Pro SEC Card using the four
captive nuts.
WARNING! Do not overtighten the captive nuts. Doing so could damage your
motherboard. Tighten captive nuts to no more than 6 1 inch/pound.
3. Install the Processor: Install a Pentium Pro processor with a heatsink and fan.
To install the processor, open the ZIF socket by first pulling the lever sideways
away from the socket's "Lock" then upwards to a 90-degree right angle. Insert the
CPU with the correct orientation. Look to see that the pins are more dense on one
half compared to the other half. With the added weight of the CPU fan, no force is
required to insert the CPU. Once completely inserted, hold down on the fan and
close the socket's lever.
WARNING! Without a fan, the CPU can overheat and cause damage to both the
CPU and the motherboard.
4. Set Jumpers: Refer to jumper settings for "CPU to BUS Frequency Ratio" and
jumpers for "BUS Frequency Selection" if you haven't set them yet.
24
III. INSTALLATION
With washer
ASUS KN97 User's Manual
With washer