Advertisement
11. Position the right and left brackets on the sides of
the CD changer, and install the two washer-
screwson each bracket.
RIGHT
BRACKET
WASHER-
SCREW
CD CHANGER
12. Remove the three self-tapping screws that secure
the console box. Retain the self-tapping screws.
SELF-TAPPING SCREW
CD
CHANGER
13. Connect the CD Changer 14-pin connector to the
BUS cable 14-pin connector.
4 of 8
LEFT
BRACKET
WASHER-
SCREW
BUS CABLE
14-PIN
CONNECTOR
CD CHANGER
14-PIN CONNECTOR
14. Using scissors, cut the protective wrap (from
step 9) in half, then wrap the halves around the
right and left stays.
PROTECTIVE WRAP
(Cut in half.)
CD
CHANGER
15. While pulling the BUS cable down and out, install
the CD changer in the console box; then,
temporally secure it in place with the three self-
tapping screws retained in step 12. Do not tighten
the self-tapping screws yet.
AII 26316-26479 (0402)
PROTECTIVE WRAP
STAY
SELF-
TAPPING
SCREW
(Temporarily
CONSOLE
BOX LID
BUS CABLE
3708050M
© 2004 American Honda Motor Co., Inc. - All Rights Reserved.
install.)
Advertisement
