Invacare Dragon User Manual page 44

•
The picture on the right shows the position of
the perforated plates (1) and the fastening
screws on the holding plates (2) for adjusting
seat height and seat angle.
The picture on the right shows the front perforated
plates. The approach is similar for the rear
perforated plates. To adjust the front perforated
plates a 13 mm open-ended spanner is required
in addition to the 5 mm Allen key.
• To adjust seat height/seat angle loosen the
screw using the spanner and remove.
•
Set the perforated plates to the desired
height/angle.
• Apply Loctite to the screw, re-insert the screw
and tighten to 40 Nm using the spanner.
44