NEC N8100-1422F User Manual page 391

8.
Select the proper SCSI Adapter and press Enter.
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-117 board is installed.)
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-116 board is installed.)
– [LSI Embedded MegaRAID (Windows XP/2003)]
(When LSI Embedded MegaRAID is used.)
Continue performing tasks according to the subsequent messages that appear.
9.
When the following message is shown, press Enter to start "Welcome to Setup".
10.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has been installed: Go on the step 14.
– Windows Server 2003 R2 has been installed: Go on the step 11.
11.
When Windows Server 2003 R2 has been installed, the [Windows Setup] screen will be
displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
You can install Microsoft Windows Server 2003 R2 DISC 2 after
the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 DISC 2.
In this case, note that the [Windows Setup] screen is not displayed.
12.
Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the optical disk drive.
Confirm the parameters and click [OK].
13.
When the installation has completed, remove Microsoft Windows Server 2003 R2 DISC 2
CD-ROM from the optical disk drive, and restart the system.
14.
When the installation has completed, be sure to execute the tasks described in "Driver
Installation and Advanced Settings" and "Updating the System" of manual.
Installing Windows Server 2003 E-9