Oni-(24,30) Wiring - Empire Comfort Systems ONR-24-1 Installation Instructions And Owner's Manual

Electronic Control Module Shield Installation.
1. Slip the split grommets over the wire harness.
2. Place the control shield into position over the control
module.
3. Feed wiring into slots on either side of the control
shield.
4. Snap the grommets into the holes on the shield to
retain and protect the wiring.
5. Complete wiring installation.
6. Secure shield to valve with two screws as shown.
GAS CONTROL
VALVE
HI/LO
Solenoid
MAIN
PILOT
RED
BLACK
Page 12

ONI-(24,30) WIRING

N/A
WHITE
GREEN
ORANGE
PILOT
(GND)
BLACK
(SENSOR)
ORANGE
(IGNITOR)
AF-4000 B/P
N/A
BROWN
IPI POWER
ELECTRONIC
CONTROL MODULE
ORANGE
RED
BROWN
BLACK
28096-11-1213