Oni-(24,30) Wiring - Empire Comfort Systems ONR-24-2 Installation Instructions And Owner's Manual

shield Installation
1. Slip the split grommets over the wire harness.
2. Place the shield into position over the control module.
3. Feed wiring into slots on either side of the control
shield.
4. Snap the grommets into the holes on the shield to
retain and protect the wiring.
5. Complete wiring installation.
6. Secure shield to valve with two screws as shown.
GAS CONTROL
VALVE
HI/LO
PILOT
Solenoid
MAIN
PILOT
ORANGE
(IGNITOR)
RED
BLACK
note: The fireplace may be operated without the remote by
connecting the brown control module wires to a wall switch. The
remote/off switch on the control module must be in the "OFF"
position.
Page 12

onI-(24,30) wIrInG

CUSTOMER PROVIDED
WALL SWITCH
BROWN
WHITE
GREEN
ORANGE
(GND)
ELECTRONIC
BLACK
CONTROL MODULE
(SENSOR)
AF-4000 B/P
ORANGE
BLACK
N/A
RED
BROWN
SECURE SHIELD TO VALVE
WITH TWO SCREWS
ELECTRONIC
CONTROL
MODULE
CONTROL MODULE
SHIELD GROMMETS
28096-23-1016