Restrictions For Mlfr To Be In The Hardware Accelerated Mode - Cisco PA-MC-T3-EC= Installation And Configuration Manual

Chapter 5 Configuring the Channelized Mode

Restrictions for MLFR to Be in the Hardware Accelerated Mode

If the restrictions in this section are met, the Multilink Frame Relay (MLFR FRF.16) bundle operates in
hardware mode by default.
•
•
•
•
OL-10589-02
The maximum supported member link bandwidth is T1. If a clear channel interface is made part of
a MLFR bundle, the bundle will operate in software mode.
All links in the bundle must be of equal bandwidth. Adding a link of unequal bandwidth causes the
MLFR bundle to go into software mode.
All links must be from the same port adapter. Adding any additional links from a different port
adapter causes the MLFR bundle to switch to software mode.
A maximum of 12 links per bundle is supported. Adding any additional links to the bundle will
causes the MLFR bundle to go into software mode.
PA-MC-T3-EC Hardware Accelerated Features and Restrictions
PA-MC-T3-EC Port Adapter Installation and Configuration
5-5