Table of Contents
Advertisement
Chapter 5
Configuring the Channelized Mode
Repeat the ping command using the IP address of the local serial interface. Using the previous example
Step 3
where the remote server's IP address was 10.0.0.10, if the local IP address is 10.0.0.5, then use the
command:
ping 10.0.0.5
If the ping is successful, proceed to Step 4. A failure indicates a configuration problem or a hardware
problem with the PA-MC-T3-EC.
Remove the local loop with the no loopback command and place the remote server or DSU in network
Step 4
loopback with the loopback remote command.
Note
The loopback remote command is only available when the framing is set to c-bit parity. If the framing
is not set to c-bit parity, the remote server will have to be placed into network loopback by someone at
the remote site.
Repeat Step 3. If the ping is successful, then the PA-MC-T3-EC and the T3 link to the remote site is
Step 5
functioning correctly. The problem is probably in the remote DSU or server configuration or hardware.
If the ping fails, then a problem exists for: the T3 link to the remote site, the remote server , the DSU
configuration, or the hardware.
OL-10589-02
PA-MC-T3-EC Port Adapter Installation and Configuration
Checking the Configuration
5-35
Advertisement
Table of Contents
