Burner; Removing The Burner; Burner Installation; Air Shutter Adjustment (Under The Burner) - Drolet SGS Owner's Manual

SGS GAS STOVES

Burner

Removing the Burner

•
Open the glass door. Remove the burner contour (2) and the deflector (3). Unscrew the two screws on
each side of the burner (1).
•
Slide the burner out from the ventury towards the left. Get it out from the stove.

Burner Installation

•
Get the burner back in place and push it towards the right until the main orifice enters into the ventury;
•
The o-ring gasket must be in place between the main orifice;
•
Screw the burner back into the bottom of the combustion chamber.

Air Shutter Adjustment (under the burner)

•
Loosen the screw of the air shutter on the ventury in order to increase/decrease the opening.
•
The factory setting for the air shutter is 3/16" open for natural gas, and fully open for propane.
•
After operating the appliance 30 minutes, the flames should have turned into nice yellow color.
WARNING :
The main orifice burner must be
well inserted into the ventury
tube, or damages during lighting
could occur.
22