Drolet SGS Owner's Manual page 15

SGS GAS STOVES
5. Remove and discard the metallic
plate (6) from the rear heat shield
using a screw driver.
just a little bit the two screws
located each side of the chimney
connector. Install the venting
hood (5) by sliding it into place.
Screw tightly in place.
6. Remove the four screws of the
valve cover (7) and slide upwards
to remove.
7. Unscrew the thermocouple (8)
from the bottom of the valve to
install interrupter
Reinstall the thermocouple (8)
into interrupter bloc (9). Connect
the two wires (10) from the hood
to the interrupter bloc (9).
Unscrew
bloc (9).
14