Drolet SGS Owner's Manual page 12

SGS GAS STOVES
Direct Vent Kit for Basement Installation AC02010:
Coaxial 4" X 6 5/8" rigid vent system with
black finish includes :
1- 45° Elbow
2- Two 24" Pipes
3- 90° Elbow
4- 24" Pipe
5- Adjustable pipe
6- Wall thimble cover
7- Wall thimble
8- Snorkel termination cap
Note: Restrictor ring B is supplied with
your stove. Insert the ring between
section 1 and 2.
1. Place the stove at the desired location ;
2. Install temporarily pipes #1, #2, #3 and #4 in order to mark the opening on the exterior wall. For a corner
installation, rotate elbow #3 so it is facing the exterior wall.
NOTE : Horizontal run should have a upward slope of at least ¼" per foot.
3. Make a 9 1/2'' x 9 1/2'' inch opening in the wall to
install the wall thimble (#7a and 7b);
4. If necessary, cut the wall thimble (#7a and 7b)
according to the wall thickness. Slide part #7a and 7b
into place and secure with 8 wood screws #10 x 1 ½";
5. Install and secure the snorkel termination cap (#8)
with 1 ½'' wood screws;
6. Install the wall thimble cover #6 using pipe #5 to make
sure you are centered. Secure with 4 black finishing
screws. Remove pipe #5;
7. Install the 45° elbow on the stove. Make sure that the
6 5/8" female and the 4" male ends are toward the
stove. Everything should tightly fit together.
NOTE : Make sure that all pipe junctions are properly
sealed with high temperature sealer paste (700°F to
1050°F) included in your stove;
8. Repeat step 7 for parts #2, 3, 4 and 5. Pipe #5 is
adjustable to facilitate
termination cap;
9. Seal the termination cap to the exterior wall to prevent
water leakage into the house ;
10. Secure the stove to the floor using the fixation holes on
each side of the pedestal.
Restrictor
ring B
the connection to the
11