Table of Contents
Advertisement
Enter the following information and click Next.
• Network name (SSID): Enter a network name or choose from a
list of existing networks. Do not change the name if it is
supplied automatically.
• Communication mode: Select Infrastructure or Ad-hoc.
• Channel: Select a channel (ad hoc only; in infrastructure
mode, the UT-1 will choose the channel automatically). Note
that if a matching SSID is found on a different channel, the
UT-1 may change the channel automatically.
• Authentication: The authentication used on the network.
Choose from open system, shared key, WPA-PSK, and
WPA2-PSK (infrastructure) or from open system and shared
key (ad hoc).
• Encryption: The encryption used on the network. The options
available depend on the authentication used.
Open: None; 64- or 128-bit WEP
Shared: 64- or 128-bit WEP
WPA-PSK: TKIP; AES
WPA2-PSK: AES
• Encryption key: If the network uses encryption, enter the
network key. The number of characters required depends on
the type of key used:
Number of characters (ASCII)
Number of characters (hex)
Note that depending on the device and the key setting used,
the UT-1 may fail to connect. If this occurs, try choosing a
different key setting.
• Key Index: If WEP64 or WEP128 is selected for Encryption,
choose a key index (the default index is 1). A key index is not
required when None is selected.
56
Uploading Pictures to an ftp Server
WEP (64-bit) WEP (128-bit)
5
10
TKIP, AES
13
8–63
26
64
Advertisement
Table of Contents
