Controlling; Battery Installation In The Rcu - Runco DTV-1101 Owner's Operating Manual

4

CONTROLLING

Caution: Do not display a stationary image with full brightness
and contrast for longer than 20 minutes, otherwise you risk
damage to the CRTs.

Battery Installation in the RCU

A new battery has been packaged inside the plastic bag with the
power cord. Before using the RCU, install the battery first.
Remove the battery cover on the backside of the RCU by pushing the
indicated handle a little to the bottom of the RCU. Lift the top side of
the cover at the same time (fig. 1).
Insert the new 9V battery (type 6F22S or equivalent; alkaline batteries
are recommended) in the lower compartment and connect the battery
to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Contact
plate
Battery
310a.DRW
Insert here
(behind the
plastic cover)
the 'Insert card
for RCU'.
fig.2
Controlling
fig.1
4-1