Seal The Case; Check The Operation Of The Loaded Camera - Olympus PT-EP08 Instruction Manual

Seal the Case

1 Close the Case gently while aligning the mounting projection of the rear lid and groove.
2 Turn the open/close dial counter clockwise.
• The Case is sealed.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
• Close the rear lid of the Case so that the lens cap or monitor hood strap doesn't catch. If it catches, water
leaks may result.

Check the operation of the loaded camera

After sealing the Case, check that the camera operations normally.
• Push the ON/OFF button on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial on the Case and confirm that the camera mode switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate the zoom dial on the Case and confirm that the camera's lens is controlled.
• Operate other control buttons on the Case and confirm that the camera functions properly as intended.
Close
EN
EN 14