Load The Washing Machine; Add The Detergent; Detergent And Fabric Softener Use - Simpson EZI Sensor SWT801 User Manual

Load the Washing Machine

When loading the clothes into your washing
machine, there are four things to remember:
1. Clothes must be loaded evenly around the
agitator. For best results load small items first,
followed by large items.
2. Clothes must not be wrapped around the
agitator.
3. The washing machine must not be overloaded.
Clothes must be able to move during wash.
- Model SWT801 maximum load is 8.0 kg.
- Model SWT951 maximum load is 9.5 kg.
4. The load should contain only three or four large
items, for example sheets. The rest of the load
should be small items. A mixed load of large
and small items will wash cleaner than a load of
all large items.

Detergent and Fabric Softener Use

Don't use the wrong type of detergent. You must
use a low sudsing detergent designed for front
load washing machines or high efficiency top
loaders, such as Cold Power for Front Loaders
and High Efficiency Top Loaders or detergents
labelled 'Matic'.
Don't use soap-based products in your washing
machine.
Don't use too much detergent. This can result in
excessive suds that can cause low spin speeds,
poor rinsing and overloading the motor during
spin stages of the wash program.
Don't use too little detergent because you will get
a poor wash. If you think you need more, increase
dosages by only small amounts to avoid excessive
suds.
Caution
Do not spill fabric softener on the clothes as
it may stain them.
Simpson
5
Washing Insructions

Add the Detergent

When using the washing machine for the first
time, check that the dispenser is set for the type
of detergent you will use. To do this, proceed as
follows:
1. Pull the dispenser drawer forward until it
stops.
2. Lift the front of the drawer up and forward to
remove it from the runners.
3. Check the position of the flap at the rear of
the detergent compartment in the dispenser
drawer. (Factory setting is flap up for powder.)
4. Clip the flap down if you intend to use liquid
detergent.
5. Refit the dispenser back into its runners.
Remember: If you change the type of
detergent you use, the position of the
flap will need changing. See above.
6. You are now ready to add detergent.
Measure the amount required and pour it into
the detergent compartment of the dispenser
drawer.
add detergent
When using liquid detergent, some may leak out
of the dispenser into the wash load earlier than
expected through small openings in the back of
the dispenser. The openings are to help flushing
out of detergent.
clip flap up for
powder
clip flap down for
liquid