Step 1 - Configure the TracVision System
Follow the steps below to set up the TracVision system for your
desired European Tri-Sat Mode. You will enter PC commands into the
HyperTerminal window. An example is provided in Figure 3-22.
1. Connect a PC to the maintenance port, as described in
"Connecting a PC" on page 40. You will enter the
following PC commands into the HyperTerminal
window.
2. Type HALT then press Enter.
3. Use the table below to enter the following
SATINSTALL command then press Enter.
4. Type ZAP then press Enter to restart the antenna. Wait
one minute for system startup.
Figure 3-22 Example, European Tri-Sat Mode - Europe WB Group
For Group:
Type:
Europe WB
SATINSTALL,TRISAT,EWB
Europe
SATINSTALL,TRISAT,EUR
Scandinavia
SATINSTALL,TRISAT,SCN
HALT
SATINSTALL,TRISAT,EWB
ZAP
TracVision M5/M7 User's Guide
Chapter 3 - Settings
53