KVH Industries TracVision M5 User Manual page 46

TracVision M5/M7 User's Guide
Chapter 3 - Settings
Step 3 - Configure the Receiver(s)
44
NOTE: If you are connecting multiple receivers, repeat this process for each
additional receiver. You will need to connect each receiver, one at a time, to
the RF1 cable and perform the steps below. Then, once you have completed
this process for each receiver, you can reconnect them as desired.
IMPORTANT!
This procedure must be performed while the vessel is stopped
in calm waters.
1. Ensure the receiver you wish to configure is connected
to the TracVision system's RF1 cable.
2. Turn on the TV and receiver.
3. Apply power to the TracVision system. Wait until the
tracking screen for your selected DISH 1000
configuration is displayed.
Figure 3-12 Tracking Screens
DISH 1000/61 Mode
DISH 1000/129 Mode
4. Using the receiver's remote, go to the "Point Dish/
Signal Strength" screen (press MENU, 6, 1, 1 on most
models).
5. Choose Check Switch, then press SELECT.
6. Choose Test, then press SELECT.
7. Wait at least 15 minutes before proceeding. Disregard
messages on the TV stating the test is complete; you
must wait 15 minutes before proceeding.
IMPORTANT!
Please be patient. The Check Switch test takes approximately 15
minutes to complete. Disregard any messages on the TV stating
the test is complete; the antenna must perform additional
operations before proceeding.
Tracking DISH 119
110 Menu 61
Tracking DISH 119
110 Menu 129