KVH Industries TracVision M5 User Manual page 24

TracVision M5/M7 User's Guide
Chapter 2 - Operation
20
Dual-Sat Manual Mode - Required for Three or More Receivers and All
Custom Dual-Sat Setups
Circular TracVision M5/M7 systems with three or more receivers
require the use of a multiswitch. Since multiswitches interfere with
communications between the receivers and the antenna, the system
must be set up in Manual mode. When manual mode is enabled, you
can use the receiver's remote control to change channels on the
currently selected satellite. If you need to switch satellites, simply use
the buttons on the front of the ADCU (see Figure 2-13 and
Figure 2-14). You can use the receivers' remote controls to switch
between the channels on the currently selected satellite.
Figure 2-13 Dual-Sat Manual Mode - Receiver/ADCU Controls
Antenna
RF2 RF1
Buttons used to
switch satellites
Grounding
Block
Multiswitch
Figure 2-14 Dual-Sat Manual Mode - ADCU Display
Tracking <Sat A>
<Sat B> Menu
Press for
Sat B
ADCU GyroTrac Sensor
All Receivers
Changes
channels on
current satellite
Selected
Satellite