Setting Oven Controls - Kenmore 790.3103 Use & Care Manual

Setting Oven Controls

Setting the Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press . "CLO" will appear in the display (Figure 2).
2. Press 1
3 0
(Figure 3). "CLO" will stay in the display. Press
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold
display. "12h" (Figure 5) or "24h" (Figure 6) appears in the
display and the control beeps once.
Flex
2. Press to switch between the 12 and 24 hour time of day
Clean
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press to accept the change or press
START
change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
pads to set the time of day to 1:30
for 7 seconds. "CLO" will appear in the
. "CLO"
START
for 7 seconds
to reject the
STOP
17
TIMED DELAY
DOOR LOCKED
PRESS
TIMED DELAY
DOOR LOCKED
1
3 0
START
TIMED DELAY
DOOR LOCKED
TIMED DELAY
DOOR LOCKED
Flex
Clean
or
START
STOP
TIMER CONV BAKE BROIL
CLEAN ROAST WARM PROBE
Figure 1
DISPLAY
TIMER CONV BAKE BROIL
CLEAN ROAST WARM PROBE
Figure 2
TIMER CONV BAKE BROIL
CLEAN ROAST WARM PROBE
Figure 3
TIMER CONV BAKE BROIL
CLEAN ROAST WARM PROBE
Figure 4
Figure 5
Figure 6