Machine Operation - Viper BARRACUDA Owner's Manual

MACHINE OPERATION

PRIOR TO VACUUMING CARPETS
1) Inspect power cable and extension
cable for damage. Replace cable if
damage is found.
2) Ensure filter bag is properly installed
NOTE: Never operate machine without
filter bag installed. This could cause
damage to the vacuum motor.
3) Set proper height adjustment for carpet
being cleaned.
CARPET VACUUMING
1) Depress foot pedal and lower vacuum
head to floor.
2) Turn on power switch.
3) Operate by using standard vacuuming
procedures.
4) Check bag periodically to see if it is
full. Replace if necessary.
5) To clean under desks or other tight
areas, depress the foot pedal an
additional time to lower the handle
even further.
OPERATING HINTS
1) Overlap cleaning path by approx. 2
inches
2) Work away from power outlet and
power cable in order to avoid damage
to the power cable.
3) Occasionally check the bag for fullness
& replace as necessary.
4) If brush stops spinning, there may be
an obstruction in the brush. Unplug the
power cable, raise the brush off the
floor and check for an obstruction.
Check & reset the brush circuit breaker
located on the bottom of the brush
housing.
USE OF ACCESSORY TOOLS
NOTE: Accessory tools are available as an
option. Kit VA51061 includes: Dusting
brush, crevice tool, 8' vacuum hose.
1) Machine must be in upright position
whenever using attachment tools.
2) Remove accessory hose plug on the
vacuum intake port on rear of machine.
3) Connect (optional) vacuum hoses to
intake port & connect desired
accessory tool to end of hose.
4) Turn on vacuum switch and operate
tool using normal vacuuming
procedures.
VACUUM BAG INSTALLATION &
REMOVAL
1) Unlock rear door latch, and allow door
to hinge open.
2) Place paper bag / filter into tank
opening.
3) On paper bag / filter, slide rubber
vacuum collar onto vacuum intake
spout.
4) Close rear door and lock into place.