Advertisement
WOLF CARPET SPOTTER - SETUP
!!! Read operators manual thoroughly
prior to operating or servicing this
machine!!!
Carefully check the shipping carton for signs of
damage. Report any carton damage to carrier
immediately.
Check carton contents to ensure carton is complete.
Contact your Viper distributor if anything is
missing.
Contents:
l
Wolf Carpet Spotter
l
Vacuum & Solution hoses
l
Hand tool
l
!!! Read operators manual
thoroughly prior to operating or
servicing this machine!!!
1) Using a hose or bucket, fill tank with a
maximum of 1 gallon of water.
!!! Do not use flammable liquids or
operate machine in or near
flammable liquids or vapors!!!
2) Connect the solution hose and vacuum hose to
the machine.
3) Connect the power cable to a grounded wall
outlet. (see grounding instructions)
MACHINE OPERATION
PRIOR TO REMOVING SPOTS
1) Inspect power cable for damage.
Replace cable if damage is found.
2) Vacuum carpet to remove debris prior to
extracting the spot.
SPOT REMOVAL
1) Turn on vacuum / pump switch.
NOTE: Solution will only spray when the spray
handle(on the hand tool) is pulled.
2) To start cleaning, pull the spray handle (hand
tool) and begin to pull the tool backwards
over the spot.
NOTE: For best cleaning results, use
the built-in agitation brush on the hand
tool to help loosen stain.
3) Release spray handle when you have reached
the end of the spot. Continue to pull hand tool
back for another 5 inches to pick up excess
solution.
4) Continue until spot is removed.
3
Hide quick links:
Advertisement
