Wheel Replacement
always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
if you damage one or more wheels, you can easily
replace the wheels.
tools Needed
•
hex Wrench 5mm ....................................... 1
to replace a wheel:
1.
disConnECt thE poWEr FEEdEr
FroM poWEr!
-22-
2.
Using a 5mm hex wrench, remove the two
wheel retaining cap screws (Figure 16).
Figure 16. Wheel replacement.
Qty
3.
swap the old wheel with the new.
4.
reinstall the two cap screws, and tighten in
an alternating pattern until the wheel is sec-
cure.
Model g4181/g7873 1-hp power Feeder
Cap
screw