Specifying A Destination - Garmin Skoda Navigation User Manual

The integrated GPS receiver is not initialised for the first time until the
navigation application is started for the first time. It can take up to
5 minutes to initialise the GPS receiver for the first time.
Each time you switch on the navigation device after this, GPS reception
will start within a short time.
If the navigation device has not been switched on for more than a week,
it can take up to 10 minutes to re-initialise the receiver.
Note: Directly after the GPS symbol indicates the GPS ready state, the
accuracy of the positioning may be reduced for a few minutes.
In the top right hand corner of the screen you will see the GPS symbol.
As soon as data from at least three satellites is received, the symbol will
change to
Note: Initialisation takes the least time if you do not start driving until
the initialisation has finished.
For more details about the GPS symbol refer to chapter "GPS" on
page 21.
Returning to the Navigation window
The N
started.
If another window of the navigation application is open, tap on
Tap on
►
opened.
7.2

Specifying a destination

Under New destination you can enter destinations to which you have
not yet navigated or which you have not saved. Here you can
enter the address of the destination. (Refer to "Entering a
►
destination address " on page 33)
enter the coordinates of the destination. (Refer to "Enter
►
coordinates" on page 35)
select a point of interest. (Refer to "Points of interest" on page 36)
►
select a destination with the Direct Access function. (Refer to
►
"Direct access to POI" on page 40)
Note: The first time that you want to enter a new destination you will be
asked to select the country in which your destination is situated.
Navigation
(GPS ready).
window opens when the navigation application is
AVIGATION
(Back). This will return you to the window you came from.
(Back) repeatedly until the N
User's manual maps + more
window is
AVIGATION
- 31 -