Switching Lights On And Off; Day Light Function (Daylight Driving Light); Automatic Driving Lamp Control - Skoda Octavia Owner's Manual

Switching lights on and off

ä
First read and observe the introductory information and safety warn-
ings on page 44.
Switching on the parking light
›
Turn the light switch » Fig. 22 to position .
Switching on the low beam and main beam
›
Turn the light switch to position .
›
Push the main beam lever slightly forward in the spring-tensioned position to
switch on the main beam » Fig. 28.
Switching off lights (except daylight driving lights)
›
Turn the light switch to position 0.

DAY LIGHT function (Daylight driving light)

ä
First read and observe the introductory information and safety warn-
ings on page 44.
Switching on daylight driving lights
›
Turn the ignition on and turn the light switch to position 0 or . .
Deactivating the function daylight driving lights
›
Pull the turn signal light lever towards the steering wheel within 3 seconds of
switching on the ignition and at the same time, slide it downwards and hold it in
this position for at least 3 seconds.
Fig. 22
Dash panel: Light switch
Activating the function daylight driving lights
›
Pull the turn signal light lever towards the steering wheel within 3 seconds of
switching on the ignition and at the same time, slide it upwards and hold it in
this position for at least 3 seconds.
On vehicles with an information display, the daylight driving lights can also be ac-
tivated or deactivated via the menu:
Settings
■
■ Lights & Vision
On vehicles with separate lights for daylight driving lights in the fog lights or in
the front bumper, the parking lights and the licence plate light do not come on
when activating the function daylight driving lights (neither front nor rear).
If the vehicle is not equipped with separate lights for daylight driving lights, the
combination of the low beam, the parking lights (front and rear) including the li-
cence plate light is used as daylight driving lights.
When the daylight driving lights are switched on, the illumination of the instru-
ment cluster is switched off, however, it is switched on in the position  when
it is dark and the low beam shines with full brightness (100 % of the perform-
ance).

Automatic driving lamp control


ä
First read and observe the introductory information and safety warn-
ings on page 44.
Switching on automatic driving lamp control
›
Turn the light switch » Fig. 23
Switching off automatic driving lamp control
›
Turn the light switch to the position 0,  or .
Fig. 23
Dash panel: Light switch
to position .
Lights and Visibility

£
45