Rear Fog Light; Instrument Lighting - Skoda Octavia Owner's Manual

The fog lights with the function CORNER are adjusted according to the steering
angle or after switching on the turn signal light
›
the vehicle is stationary and the engine is running or it moves with a speed of
maximum 40 km/h;
›
the daylight driving lights are not switched on;
›
the low beam is switched on or the light switch is in the position  and the
intensity of the ambient light causes the low beam to be switched on;
›
the fog lights are not switched on;
›
no reverse gear is engaged.
Note
If the reverse gear is engaged during the active function CORNER, both fog lights
illuminate.

Rear fog light

ä
First read and observe the introductory information and safety warn-
ings on page 44.
Switching on the rear fog light
›
First of all, turn the light switch to position  or 
›
Pull the light switch to position
If the vehicle is not fitted with fog lights
on by turning the light switch to the position  or  and is pulled out directly to
the position . This switch does not have two positions, but only one position.
2
The warning light lights up in the instrument cluster when the rear fog light is

switched on » page 22.
Only the rear fog light on the trailer lights up if the vehicle has a factory-fitted
towing device or a towing device from ŠKODA original accessories and it is driv-
en with a trailer and the rear fog light switched on.
The rear fog light is located in the rear light array on the driver's side.
1)
If both switch on versions are conflicting, for example if the steering wheel is turned to the left and
the right turn signal light is switched on, the turn signal light has the higher priority.
48
Using the system
in the following circumstances:
1)
» Fig. 24.
.
2
» page 47, the rear fog light is switched
Instrument lighting 

ä
First read and observe the introductory information and safety warn-
ings on page 44.
›
Switch on the light.
›
Turn the control dial » Fig. 25
ing.
The illumination intensity of the Information display
ly. It is only possible to adjust the instrument lighting with the control dial if the
light intensity drops below the set value of the light sensor.

Fig. 25
Dash panel: Instrument lighting
to the desired intensity of the instrument light-
» page 18 is set automatical-
