Table of Contents
Advertisement
Front view
SELECT
1
1
Input Select
2
Power
3
Standby LED
4
Setup
5
Enter
1.
Input selector
Input selector
Turn this knob to select the source you require. The operation of the input
selector is described in more detail under Basic Amplifier Controls - Input
selector.
The input selector is the equivalent of the LEFT/RIGHT buttons on the remote
control.
Power
Press the POWER button to turn the unit on and off. The 882 must be connected
to the mains, with the power switch on the rear panel in the 'on' position
(position I).
Standby LED
When you switch the 882 on using the power switch on the rear panel, the unit
initially enters its standby mode and the standby LED illuminates. As soon as the
882 is ready for use, the standby LED extinguishes and the display becomes
active. When you switch the integrated amplifier off, the LED flashes for
approximately 5 seconds, during which time you cannot switch the unit back on
again.
POWER
SETUP
ENTER
SPEAKERS
2
3
4
5
6
6
882 Integrated Amplifier
BALANCE
MUTE
7
8
9
6
Speakers
7
Balance
8
Mute
9
Volume Control
VOLUME
882 INTEGRATED AMPLIFIER
Advertisement
Table of Contents
