Basic Amplifier Controls; Switching On And Off; Input Select - Lindemann 882 Owner's Manual

Basic amplifier controls

Switching on and off

To switch the unit on, press the POWER button on the front panel or on the
remote control.
To switch the integrated amplifier off, press the POWER button a second time.
This will switch the unit into standby mode. You will see the message: Power
Down... in the display.
After a short interval this will disappear and the blue standby LED will flash for
about 5 seconds. It is not possible to switch the component on again during this
time.
Use the POWER button to switch the unit on and off in everyday use. If the
integrated amplifier is connected to a Lindemann power amplifier and/or CD
player, the power amplifier and/or CD player will be powered up and down at
the same time as the integrated amplifier.

Input select

Remote control:
Use the LEFT/RIGHT- button to select the signal source.
Front panel:
Turn the input selector knob to select the signal source.
If you have deactivated certain inputs using the Input Enable menu option, these
will not be shown and cannot be selected.
If you have connected an 820 CD/SACD player via SYSCOM, you can now access
the 820's four digital inputs from the 882 (inputs 6-9). To use these digital inputs,
you must connect the balanced analog output of the 820 to Input 2 on the 882.
When you select a digital input on the 882, the blue LED for Input 2 (analog
input) illuminates together with the yellow LED to indicate that a digital input is
active. The name of the digital input on the 820 is retrieved and displayed by the
882.
Analog
882
SYSCOM
12
882 Integrated Amplifier
820
Digital