Solving Problems - Electrolux EOC617 User Manual

cleaning your
oven door
Re-assembling top door trim
• T ake hold of the top door trim at each side and position it
to the inside edge of the glass.
• P ush the trim down with its top edge over glass panel until
the clip snaps in on each side of the trim.
• P ush the middle of the trim down to ensure it is straight
and firm against the glass panel.
Fitting the oven door
• T ake hold of the oven door with a hand on each side and
with the door at an angle of 45º, position the recesses at
the bottom of the door onto the hinge arms of the oven.
Let the door slide down the hinge arms as far as it will go.
20 CLEANING YOUR OVEN DOOR Built-in Cooking
• O pen the door fully to access the hinges then rotate the
'stirrups' (highlighted in the image) on both hinges back to
their original positions.
The oven door may now be closed.

solving problems

Faults
If there is a problem with the oven and/or grill, please:
• C heck the points listed below before calling for service.
It may be possible to avoid a call by fixing the problem
yourself – and so continue cooking.
• F or cooking problems refer to page 14.
Note: We may charge for service even in the guarantee
period if your problem is due to the causes listed below.
Problem Possible Cause
Oven or grill not working • Time of day not set.
• Power not turned on.
• Controls are incorrectly set.
• Household fuse has blown or power supply is off.
• Child-proof oven lock activated. (Refer to operating instructions).
Note: If the household fuse continues to blow, call the electrolux Customer Care Centre.
Oven light not working • Lamp blown or loose in socket.
• Household fuse has blown.
Note: If the household fuse continues to blow, call the electrolux Customer Care Centre.
Oven not heating enough • Foil or trays on bottom of oven.
Oven not working • Timer is in "AUTO" mode. (Refer to timer operating instructions)
• Household fuse has blown.
Note: If the household fuse continues to blow, call the electrolux Customer Care Centre.
Timer flashing on display • Power failure or interruption.
Note: Reset time of day and any cooking functions you were using. (Refer to tIMeR operating instructions).
Unit smoking when first used • Protective oils being removed.
Condensation building up • R educe amount of water used in cooking. (Some condensation is normal)
Door cannot be replaced • Stirrup not engaged properly.
after removal
Shelves tight in oven • Shelf not in correct orientation
When you need information, service or replacements please quote:
1. Model Number
2. Serial Number: You can find these on the data plate, which can be seen when the oven door is open. If you need more information, please contact the
Customer Care Centre on 1300 363 640 (Australia – Centre is open 8.00am to 5.00pm Monday to Friday EST) Or 09 573 2384 (New Zealand –
Centre is open 8.00am to 5.00pm Monday to Friday). Only authorised service centres should carry out servicing. Otherwise warranty may be void.
If you have a warranty or spare parts enquiry, you should call the numbers listed on the back page.
Data Plate
When you need information, service or replacement parts please:
• T ell us the 1. Model, 2. Model Number & 3.
Serial Number shown on the data plate.
The data plate is visible when the oven or grill door is open.
Built-in Cooking SOLVING PROBLEMS 21