NOTE: Please read all instructions carefully before using this product Table of Contents MARCY DIAMOND ELITE Safety Notice WEIGHT BENCH Hardware Pack MD-2080 Assembly Instruction Parts List Warranty Ordering Parts Model MD 2080 Retain This Manual for Reference 08-04-09 OWNER'S ®...
WARRANTY....................… ORDERING PARTS..................BEFORE YOU BEGIN Thank you for selecting the MARCY DIAMOND ELITE Weight Bench MD- 2080 by IMPEX ® INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
The warning label shown here have been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-888-8899 for replacements. Apply the label in the location shown. Hardware Pack NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size.
Page 6
Tools Required for Assembling the Machine: Two Adjustable Wrenches. NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram 1) A.) Do not tighten Nuts and Bolts until instructed to do so. B.) Connect the two Upright Beams (#1) by a Cross Brace (#2) in the mid-span.
Do not tighten Nuts and Bolts until instructed to do so. Attach the Main Seat Support (#3) to the Cross Brace (#2). Secure it with two M10 x 2 1/8” Carriage Bolts (#24), one 4 3/8” x 3 3/8” Bracket (#12), two Ø ¾” Washers (#33), and two M10 Aircraft Nuts (#35).
STEP 3 (See Diagram 3) A.) Attach the side-holes on the two Backrest Supports (#8) to the pivot on the Main Seat Support (#3). Place the other end of the Backrest Supports rest against the Backrest Adjustment Bar (#6). B.) Attach the Backrest Board (#11) to the Backrest Supports. Secure it with four M6 x 1 3/8”...
STEP 4 (See Diagram 4) A.) Attach the Leg Developer (#9) to the open bracket on the Front Post (#5). Secure it with one M10 x 2 3/8” Hex Bolt (#27), one Ø ¾” Washer (#33), and one M10 Aircraft Nut (#35).
IMPEX. IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in connection with the use or performance of the product or other damages with respect to any economic loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other consequential damages or whatsoever natures.